สร้างเว็บEngine by iGetWeb.com
Cart รายการสินค้า (0)

Cylinder & Guide Roller 

This product guides the material to the exact position before it reaches the printing point or cutting point.

Examples of Guide Roller Installation

The end pivot type is divided into the single type which has one roller and the double type which has two rollers. One of the types is selected depending on the line. It is used only when the material to be handled has elasticity and can also easily absorb the change in tension of both edges of the material. The capability of installing it in the middle of the line with relative ease is an added advantage.

The angle at which the material is bent on the guide roller is essentially 90°and if there is no slipping phenomenon between the roller and the material, the angle may be slightly adjusted.

Be careful as, if the system is unreasonably installed in close proximity between the entering point and the roller, it may cause an uncontrollable situation or wrinkles (creases) on the material. Install the sensor vertically (90°) to the material. 


PR-MCD-C23/C23P (Web Guiding Device) 

PR-MCD-C23 model is an EPC/CPC system which has pursued easiness of use, cost, and performance.
Using the center pivot method in which the load on the materialis small and being a controller and sensor integrated type, it provides quick and precise control.

No adjustment is required at the beginning other than adding the control power. It can be safely used for a long period of time as maintenance is easy.
It is optimal for control of low tension of flexible materials.
Simple structure, rugged apparatus, and low cost have been materialized 


Guide Roller 




view